Share via


Event ID 1032 — WDSServer Network Availability

Applies To: Windows Server 2008

Network connectivity makes communication possible among the WDSServer service, client computers, and Active Directory directory services. Without this communication, the WDSServer service cannot deploy images to client computers. 

Event Details

Product: Windows Operating System
ID: 1032
Source: WDSServer
Version: 6.0
Symbolic Name: E_WDSSERVER_RPC_INVALID_ENDPOINT
Message: A request was received by the RPC server on %1 endpoint from %2 but there is no provider registered for %1 endpoint. This can happen if the provider failed to initialize but was not marked as critical or if a malicious code is trying to probe for available services. The binary data contains the first 32 bytes of the request.

Resolve

Contact the vendor or analyze network traffic

If you also received WDSServer event 512, this means that a noncritical provider failed. Because only custom providers are marked as noncritical, this one must be a custom provider. You should contact the provider's vendor for troubleshooting guidelines.

If you did not receive WDSServer event 512, this means that a computer may be sending out malicious code. To resolve this issue, obtain a network trace that shows the failed boot attempt. It is a best practice to obtain this trace from the client and server simultaneously to accurately assess whether the failure is occurring at the sending server or the receiving client. You do this by using the following steps:

  1. Place a client and a third computer (laptop or desktop) on a hub.
  2. Start network traces from the server and the third computer.
  3. Start the client by doing a network boot (a PXE boot).

Analyze the network traffic to determine which computer the invalid packets are coming from. Then determine which process is sending the packets, and stop the offending process. If you are using Microsoft Network Monitor to obtain the traces, ensure that the buffer size is at least 20 MB. If you configure a buffer size too small for the capture, the data packets will not appear in the capture output.

To download Network Monitor, see https://go.microsoft.com/fwlink/?LinkID=94770.

Verify

You can verify network connectivity either from a client computer or from the server by using one of the following two procedures.

To verify that the server has connectivity (from a client computer):

  1. Open the Command Prompt window. (Click Start, point to All Programs, click Accessories, and then click Command Prompt.)
  2. At the command prompt, type ping <IP address|fully qualified domain name> to contact the Windows Deployment Services server.
  3. Try to boot the client computer by doing a Pre-Boot Execution Environment (PXE) boot. Make sure that the boot menu and image selection pages are displayed.

To verify that the server has connectivity (from the Windows Deployment Services server):

  1. Open the Command Prompt window. (Click Start, point to All Programs, click Accessories, and then click Command Prompt.)
  2. At the command prompt, type ping <IP address|fully qualified domain name> to contact a remote computer.

WDSServer Network Availability

Windows Deployment Services