Share via


Run iLO Command

Applies To: System Center 2012 - Orchestrator, System Center 2012 R2 Orchestrator

The Run iLO Command activity is used in a runbook to run a command that can be used to perform management activities such as Create User, Get Power State, and Set Configuration.

The activity publishes all of the data from the required and optional properties into published data. The following tables list the required and optional properties and published data for this activity.

Run iLO Command Required Properties

Element

Description

Valid Values

Lookup

The iLO command to run

The iLO command to run

Create user

Delete user

Get user (iLO v2)

Get user (iLO v3)

Modify user (iLO v2)

Modify user (iLO v3)

System reset

Hard system reset

Soft system reset

Start system

Stop system

Get power state

Get configuration

Set configuration

Set virtual floppy

Set virtual CDROM

Update firmware (iLO v2)

Yes

Fields

Required fields for the selected command.

String

No

Run iLO Command Optional Properties

Element

Description

Valid Values

Lookup

Fields

Optional fields can be added to the Fields list by clicking Select fields.

String

No

Run iLO Command Published Data

Element

Description

Value type

Command

Selected command

String

Command line

Command line for command

String

Connection name

Named connection

String

Command status

Status of command

String

Error output

Command error output

String

Exit code

Exit code of command

String

Private Key

SSH private key

String

SSH Address

IP address or network name

String

SSH user

SSH username

String

Standard output

Standard output of command

String

Warning

The Run iLO Command activity in runbooks imported from Opalis 6.3 when opened for editing in the Runbook Designer will display an error dialog with no message. To remove this error close the error message by clicking OK. Record your command and field values for re-entry. Then reselect the command and re-enter the field values.

When importing runbooks that contain Get user or Modify user activities from Opalis 6.3, clicking on the activities Get user or Modify user will display a message “ Command not found“. The commands should be updated to the specific version activity i.e. Get user (iLO v2) or Get user (iLO v3) manually.

Other Activities

The Integration Pack for HP iLO and OA contains the following additional activities:

Run OA Command