Export (0) Print
Expand All

Remove-MailboxDatabase

 

Applies to: Exchange Server 2013

Topic Last Modified: 2014-03-05

This cmdlet is available only in on-premises Exchange Server 2013.

Use the Remove-MailboxDatabase cmdlet to delete a mailbox database object.

For information about the parameter sets in the Syntax section below, see Syntax.

Remove-MailboxDatabase -Identity <DatabaseIdParameter> [-Confirm [<SwitchParameter>]] [-DomainController <Fqdn>] [-WhatIf [<SwitchParameter>]]

This example removes the mailbox database MailboxDatabase01.

Remove-MailboxDatabase -Identity MailboxDatabase01

If the mailbox database has a database copy, the Remove-MailboxDatabase cmdlet also removes the copy.

The Remove-MailboxDatabase cmdlet removes only the database object from Active Directory. It doesn't remove the physical database files. You must remove the database files manually after you run the Remove-MailboxDatabase cmdlet.

You need to be assigned permissions before you can run this cmdlet. Although all parameters for this cmdlet are listed in this topic, you may not have access to some parameters if they're not included in the permissions assigned to you. To see what permissions you need, see the "Mailbox Database Permissions" section in the Recipients permissions topic.

 

Parameter Required Type Description

Identity

Required

Microsoft.Exchange.Configuration.Tasks.DatabaseIdParameter

The Identity parameter specifies the mailbox database to remove. You can use one of the following values:

  • GUID

  • Distinguished name (DN)

  • Name of the mailbox database

Confirm

Optional

System.Management.Automation.SwitchParameter

The Confirm switch causes the command to pause processing and requires you to acknowledge what the command will do before processing continues. You don't have to specify a value with the Confirm switch.

DomainController

Optional

Microsoft.Exchange.Data.Fqdn

The DomainController parameter specifies the fully qualified domain name (FQDN) of the domain controller that writes this configuration change to Active Directory.

WhatIf

Optional

System.Management.Automation.SwitchParameter

The WhatIf switch instructs the command to simulate the actions that it would take on the object. By using the WhatIf switch, you can view what changes would occur without having to apply any of those changes. You don't have to specify a value with the WhatIf switch.

To see the input types that this cmdlet accepts, see Cmdlet Input and Output Types. If the Input Type field for a cmdlet is blank, the cmdlet doesn’t accept input data.

To see the return types, which are also known as output types, that this cmdlet accepts, see Cmdlet Input and Output Types. If the Output Type field is blank, the cmdlet doesn’t return data.

 
Was this page helpful?
(1500 characters remaining)
Thank you for your feedback
Show:
© 2014 Microsoft