Export (0) Print
Expand All
Expand Minimize
This topic has not yet been rated - Rate this topic

Remove-AutodiscoverVirtualDirectory

 

Applies to: Exchange Server 2013

Topic Last Modified: 2013-01-11

Use the Remove-AutodiscoverVirtualDirectory cmdlet to remove the Autodiscover virtual directory associated with the Autodiscover service on a computer running Microsoft Exchange Server 2013.

For information about the parameter sets in the Syntax section below, see Syntax.

Remove-AutodiscoverVirtualDirectory -Identity <VirtualDirectoryIdParameter> [-Confirm [<SwitchParameter>]] [-DomainController <Fqdn>] [-WhatIf [<SwitchParameter>]]

This example removes the Autodiscover virtual directory from the site autodiscover.contoso.com on the Client Access server CAS01.

Remove-AutodiscoverVirtualDirectory -Identity "CAS01\autodiscover(autodiscover.contoso.com)"

You need to be assigned permissions before you can run this cmdlet. Although all parameters for this cmdlet are listed in this topic, you may not have access to some parameters if they're not included in the permissions assigned to you. To see what permissions you need, see the "Autodiscover virtual directory settings" entry in the Clients and Mobile Devices Permissions topic.

 

Parameter Required Type Description

Identity

Required

Microsoft.Exchange.Configuration.Tasks.VirtualDirectoryIdParameter

The Identity parameter specifies the name or GUID of an Autodiscover virtual directory. The Identity parameter is represented as: ServerName\VirtualDirectoryName (WebsiteName).

Confirm

Optional

System.Management.Automation.SwitchParameter

The Confirm switch causes the command to pause processing and requires you to acknowledge what the command will do before processing continues. You don't have to specify a value with the Confirm switch.

DomainController

Optional

Microsoft.Exchange.Data.Fqdn

The DomainController parameter specifies the fully qualified domain name (FQDN) of the domain controller that writes this configuration change to Active Directory.

WhatIf

Optional

System.Management.Automation.SwitchParameter

The WhatIf switch instructs the command to simulate the actions that it would take on the object. By using the WhatIf switch, you can view what changes would occur without having to apply any of those changes. You don't have to specify a value with the WhatIf switch.

To see the input types that this cmdlet accepts, see Cmdlet Input and Output Types. If the Input Type field for a cmdlet is blank, the cmdlet doesn’t accept input data.

To see the return types, which are also known as output types, that this cmdlet accepts, see Cmdlet Input and Output Types. If the Output Type field is blank, the cmdlet doesn’t return data.

 
Did you find this helpful?
(1500 characters remaining)
Thank you for your feedback
Show:
© 2014 Microsoft. All rights reserved.