Export (0) Print
Expand All
0 out of 1 rated this helpful - Rate this topic

Configure the IP Address

 

Applies to: Exchange Server 2013, Exchange Online

Topic Last Modified: 2012-11-11

Before you create a Unified Messaging (UM) IP gateway, you must first set the IP address or the fully qualified domain name (FQDN) on the VoIP gateway, IP PBX, or session border controller (SBC) that you're using. Then, when you create the UM IP gateway, you set the IP address or FQDN. You can change the IP address or FQDN later.

You can configure the IP address or FQDN using either the EAC or the Shell. In the EAC, the Address box on the UM IP gateway page can accept an IPv4 IP address, an IPv6 address, or an FQDN. You can also use the Address parameter on the Set-UMIPGateway cmdlet in the Shell to set an IPv4 IP address, an IPv6 address, or an FQDN. If you create a UM IP gateway using an FQDN, you must create the appropriate HOST A records in your DNS forward lookup zone. If the DNS configuration for the UM IP gateway is changed, you must disable and then enable the UM IP gateway to make sure that its configuration information is updated correctly.

For additional management tasks related to UM IP gateways, see UM IP Gateway Procedures.

  • Estimated time to complete: 2 minutes.
  • You need to be assigned permissions before you can perform this procedure or procedures. To see what permissions you need, see the "UM IP gateways" entry in the Unified Messaging Permissions topic.
  • Before you perform these procedures, confirm that a UM dial plan has been created. For detailed steps, see Create a UM Dial Plan.
  • Before you perform these procedures, confirm that a UM IP gateway has been created. For detailed steps, see Create a UM IP Gateway.
  • For information about keyboard shortcuts that may apply to the procedures in this topic, see Keyboard Shortcuts in the Exchange Admin Center.
tipTip:
Having problems? Ask for help in the Exchange forums. Visit the forums at: Exchange Server, Exchange Online, or Exchange Online Protection.
  1. In the EAC, navigate to Unified Messaging > UM IP Gateways, select the UM IP gateway that you want to modify, and then click Edit Edit Icon.
  2. On the UM IP gateway page, in the Address box, enter the IP address for the VoIP gateway, IP PBX, or session border controller (SBC).
  3. Click Save to save your changes.
importantImportant:
If you use an FQDN instead of an IP address on the UM IP gateway, verify that the correct DNS records have been created.

This example configures a UM IP gateway named MyUMIPGateway with an IP address of 10.10.10.1.

Set-UMIPGateway -Identity MyUMIPGateway -Address 10.10.10.1

This example configures a UM IP gateway named MyUMIPGateway with an IP address of 10.10.10.10 and listens for SIP requests on TCP port 5061.

Set-UMIPGateway -Identity MyUMIPGateway -Address 10.10.10.10 -Port 5061

This example prevents the UM IP gateway named MyUMIPGateway from accepting incoming and outgoing calls, sets an IPv6 address, and allows the UM IP gateway to use IPv4 and IPV6 addresses.

Set-UMIPGateway -Identity MyUMIPGateway -Address fe80::39bd:88f7:6969:d223%11 -IPAddressFamily Any -Status Disabled -OutcallsAllowed $false
 
Did you find this helpful?
(1500 characters remaining)
Thank you for your feedback
Show:
© 2014 Microsoft. All rights reserved.