Worksheet 1 Source and Destination Computer Information

Computer name

1. Record the computer name of the source server. To locate the computer name, on the source server click Start, click Run, and then type Cmd. At the command prompt, type Set. The computer name is listed as COMPUTERNAME.
   Source server:
   _____________________________________________________________
   
2. Decide on a computer name for the destination server that is a unique name on the network and that is not the same as the computer name of the source server.
   Destination server:
   _____________________________________________________________
   

Full DNS name for the internal domain

1. Record the full DNS name of the internal domain of the source server. To locate this information, on the source server, click Start, click Run, and then type Cmd. At the command prompt, type Set. The full DNS name of the internal domain is listed as USERDNSDOMAIN.
   DNS name:
   _____________________________________________________________
   

NetBIOS domain name

1. Record the NetBIOS domain name for the source server. To locate this information, on the source server, click Start, click Run, and then type Cmd. At the command prompt, type Set. The NetBIOS domain name is listed as USERDOMAIN.
   Source server:
   _____________________________________________________________
   

IP address of local network adapter

1. Record the IP address of the local network adapter of the source server. To locate the address, click Start, click Run, and then type Cmd. At the command prompt, type Ipconfig.
   Source server:
   _____________________________________________________________
   Decide on an IP address for the destination server that is not used on the network and that is within the same range as the IP address of the source server (for example, 192.168.16.2 and 192.168.16.3 are in the same range).
   

   Important
   If you are running a router device that also provides a DHCP Server service, the destination server IP address should be in the range of the router device address. Ensure that the router device is connected to the destination server during Windows SBS 2003 Setup so that DHCP is properly configured.

   If your source server is running a DHCP service, check the DHCP scope to locate the IP addresses that are currently in use on the network.
   
   1. On the source server, click Start, point to Programs, point to Administrative Tools, and then click DHCP.
      
   2. Double-click YourServerName, double-click Scope, and then click Address Leases. A list of computers and IP addresses appears.
      
   Destination server:
   _____________________________________________________________
   

Built-in Administrator account name

The Administrator accounts on both the source and destination servers must be named Administrator. If you renamed a built-in Administrator account to something other than Administrator, you must rename the account back to Administrator for the migration.

Source server Administrator:

________________________________________________________________

Destination server Administrator:

________________________________________________________________

Built-in Administrator account password

The Administrator account password for the destination server must be the same as for the source server. If the Administrator account password is blank, the migration will fail.

Important
For security reasons, it is recommended that you do not record the Administrator password.

Source server: (Do not record the password)

________________________________________________________________

Destination server: (Same password. Do not record.)

________________________________________________________________