Export (0) Print
Expand All
0 out of 3 rated this helpful - Rate this topic

Netsh commands for Interface ISATAP

Updated: February 8, 2008

Applies To: Windows Server 2008

This section contains the following commands.

The following entries provide details for each command.

Sets Intra-site Automatic Tunnel Address Protocol ISATAP router information.

Syntax

set router [ [ name= ] (Name | default )] [ [ state= ] ( enabled | disabled | default ) ] [[interval=] Interval ]

Parameters

name
Optional. Specifies the name of the ISATAP router.

state
Optional. Specifies the state of router name resolution.

interval
Optional. Specifies an integer that is the resolution interval (in minutes).

Examples

Following is an example of the set router command.

set router isatap enabled 1440

Sets the ISATAP state.

Syntax

set state [ state= ] ( enabled | disabled | default)

Parameters

state
Optional. Specifies whether ISATAP is enabled.

Shows the ISATAP router information.

Syntax

show router

Shows the ISATAP state.

Syntax

show state

Did you find this helpful?
(1500 characters remaining)
Thank you for your feedback

Community Additions

ADD
Show:
© 2014 Microsoft. All rights reserved.