Export (0) Print
Expand All
This topic has not yet been rated - Rate this topic

/disconnect-Client

Published: April 17, 2012

Updated: February 10, 2014

Applies To: Windows 8, Windows Server 2008, Windows Server 2008 R2, Windows Server 2012, Windows Server 2012 R2

Disconnects a client from a multicast transmission or namespace. Unless you specify /Force, the client will fall back to another transfer method (if it is supported by the client).

WDSUTIL /Disconnect-Client /ClientId:<Client ID> [/Server:<Server name>] [/Force]

 

Parameter Description

/ClientId:<Client ID>

Specifies the ID of the client to be disconnected. To view the ID of a client, type WDSUTIL /get-multicasttransmission /show:clients.

[/Server:<Server name>]

Specifies the name of the server. This can be the NetBIOS name or the fully qualified domain name (FQDN). If no server name is specified, the local server is used.

[/Force]

Stops the installation completely and does not use a fallback method. Note that Wdsmcast.exe does not support any fallback mechanism. If you do not use this option, the default behavior is as follows:

  • If you are using the Windows Deployment Services client, the client continues the installation by using unicasting.

  • If you are not using the Windows Deployment Services client, the installation fails.

ImportantImportant
You should use this option with caution because the installation will fail and the computer could be left in an unusable state.

To disconnect a client, type:

WDSUTIL /Disconnect-Client /ClientId:1

To disconnect a client and force the installation to fail, type:

WDSUTIL /Disconnect-Client /Server:MyWDSServer /ClientId:1 /Force

Did you find this helpful?
(1500 characters remaining)
Thank you for your feedback
Show:
© 2014 Microsoft. All rights reserved.