Wbadmin start sysrecovery

Applies To: Windows Server 2008, Windows Server 2008 R2, Windows Server 2012 R2, Windows Server 2012, Windows 8

Performs a system recovery (bare metal recovery) using the parameters that you specify.

To perform a system recovery with this subcommand, you must be a member of the Backup Operators group or the Administrators group, or you must have been delegated the appropriate permissions.

For examples of how to use this subcommand, see Examples.

Syntax

wbadmin start sysrecovery
-version:<VersionIdentifier>
-backupTarget:{<BackupDestinationVolume> | <NetworkShareHostingBackup>}
[-machine:<BackupMachineName>]
[-restoreAllVolumes]
[-recreateDisks]
[-excludeDisks]
[-skipBadClusterCheck]
[-quiet]

Parameters

Parameter	Description
-version	Specifies the version identifier for the backup to recover in MM/DD/YYYY-HH:MM format. If you do not know the version identifier, type wbadmin get versions.
-backupTarget	Specifies the storage location that contains the backup or backups that you want to recover. This parameter is useful when the storage location is different from where backups of this computer are usually stored.
-machine	Specifies the name of the computer that you want to recover. This parameter is useful when multiple computers have been backed up to the same location. Should be used when the -backupTarget parameter is specified.
-restoreAllVolumes	Recovers all volumes from the selected backup. If this parameter is not specified, only critical volumes (volumes that contain the system state and operating system components) are recovered. This parameter is useful when you need to recover non-critical volumes during system recovery.
-recreateDisks	Recovers a disk configuration to the state that existed when the backup was created. Warning This parameter deletes all data on volumes that host operating system components. It might also delete data from data volumes.
-excludeDisks	Valid only when specified with the -recreateDisks parameter and must be input as a comma-delimited list of disk identifiers (as listed in the output of wbadmin get disks). Excluded disks are not partitioned or formatted. This parameter helps preserve data on disks that you do not want modified during the recovery operation.
-skipBadClusterCheck	Skips checking your recovery disks for bad cluster information. If you are restoring to an alternate server or hardware, we recommend that you do not use this parameter. You can manually run chkdsk /b on your recovery disks at any time to check them for bad clusters, and then update the file system information accordingly. Warning Until you run chkdsk as described, the bad clusters reported on your recovered system may not be accurate.
-quiet	Runs the command with no prompts to the user.

Examples

To start recovering the information from the backup that was run on March 31, 2013 at 9:00 A.M., located on drive d:, type:

wbadmin start sysrecovery -version:03/31/2013-09:00 -backupTarget:d:

To start recovering the information from the backup that was run on April 30, 2013 at 9:00 A.M., located in the shared folder \\servername\shared: for server01, type:

wbadmin start sysrecovery -version:04/30/2013-09:00 -backupTarget:\\servername\share -machine:server01

Additional references

• Command-Line Syntax Key

• Wbadmin

• Get-WBBareMetalRecovery cmdlet