Export (0) Print
Expand All
2 out of 12 rated this helpful - Rate this topic

Event ID 1041 — DHCP Interface Configuration

Updated: December 11, 2007

Applies To: Windows Server 2008

red

The DHCP server interface and bindings must be configured correctly. The correct configuration of a static interface is required.

Event Details

Product: Windows Operating System
ID: 1041
Source: Microsoft-Windows-DHCP-Server
Version: 6.0
Symbolic Name: DHCP_ROGUE_EVENT_NO_NETWORK
Message: The DHCP service is not servicing any clients because none of the active network interfaces have statically configured IP addresses, or there are no active interfaces.

Resolve

Configure the DHCP server bindings

To perform these procedures, you must be a member of the Administrators group, or you must have been delegated the appropriate authority.

To configure the DHCP server bindings:

  1. At the DHCP server, click Start, point to Administrative Tools, and then click DHCP.
  2. In the DHCP snap-in, right-click the server you want to configure, click Properties, click the Advanced tab, and then click Bindings.
  3. In the Connections and server bindings list, check Local Area Connection. If the list is empty, configure a static IP address for the DHCP server.

Verify

To perform these procedures, you must be a member of the Administrators group, or you must have been delegated the appropriate authority.

To verify that the DHCP server static IP address and bindings are configured correctly, perform the following steps:

  1. At the DHCP server computer, click Start, click Run, and then type cmd.
  2. Type ipconfig /all to view the IP address configuration of the server.
  3. Examine the output. If there is no IP address listed, then the server has not been assigned a static IP address.

Related Management Information

DHCP Interface Configuration

DHCP Infrastructure

Did you find this helpful?
(1500 characters remaining)
Thank you for your feedback

Community Additions

ADD
Show:
© 2014 Microsoft. All rights reserved.