Export (0) Print
Expand All

Remove-ClientAccessArray

 

Applies to: Exchange Server 2013

Topic Last Modified: 2013-01-09

Use the Remove-ClientAccessArray cmdlet to remove a client access array from Active Directory.

For information about the parameter sets in the Syntax section below, see Syntax.

Remove-ClientAccessArray -Identity <ClientAccessArrayIdParameter> [-Confirm [<SwitchParameter>]] [-DomainController <Fqdn>] [-WhatIf [<SwitchParameter>]]

This example removes the client access array CASArray1.

Remove-ClientAccessArray -Identity "CASArray1"

This example removes the client access array CASArray1 after confirmation is specified.

Remove-ClientAccessArray -Identity "CASArray1" -Confirm $true

This example removes the client access array NLBArray2.

Remove-ClientAccessArray -Identity "NLBArray2"

A client access array is a grouping of Client Access servers in a load-balanced array. You can use the Remove-ClientAccessArray cmdlet to remove a client access array.

You need to be assigned permissions before you can run this cmdlet. Although all parameters for this cmdlet are listed in this topic, you may not have access to some parameters if they're not included in the permissions assigned to you. To see what permissions you need, see the "Client Access server array settings" entry in the Clients and Mobile Devices Permissionstopic.

 

Parameter Required Type Description

Identity

Required

Microsoft.Exchange.Configuration.Tasks.ClientAccessArrayIdParameter

The Identity parameter specifies the client access array.

Confirm

Optional

System.Management.Automation.SwitchParameter

The Confirm switch causes the command to pause processing and requires you to acknowledge what the command will do before processing continues. You don't have to specify a value with the Confirm switch.

DomainController

Optional

Microsoft.Exchange.Data.Fqdn

The DomainController parameter specifies the fully qualified domain name (FQDN) of the domain controller that writes this configuration change to Active Directory.

WhatIf

Optional

System.Management.Automation.SwitchParameter

The WhatIf switch instructs the command to simulate the actions that it would take on the object. By using the WhatIf switch, you can view what changes would occur without having to apply any of those changes. You don't have to specify a value with the WhatIf switch.

To see the input types that this cmdlet accepts, see Cmdlet Input and Output Types. If the Input Type field for a cmdlet is blank, the cmdlet doesn’t accept input data.

To see the return types, which are also known as output types, that this cmdlet accepts, see Cmdlet Input and Output Types. If the Output Type field is blank, the cmdlet doesn’t return data.

 
Was this page helpful?
(1500 characters remaining)
Thank you for your feedback
Show:
© 2014 Microsoft