Export (0) Print
Expand All
Expand Minimize

DNS: Valid network interfaces should precede invalid interfaces in the binding order

Updated: October 15, 2010

Applies To: Windows Server 2008, Windows Server 2008 R2, Windows Server 2012

This topic is intended to address a specific issue identified by a Microsoft Baseline Configuration Analyzer or Best Practices Analyzer scan. You should apply the information in this topic only to computers that have had the DNS Microsoft Baseline Configuration Analyzer or DNS Best Practices Analyzer run against them and are experiencing the issue addressed by this topic. For more information about best practices and scans, see Best Practices Analyzer.

 

Operating System

Windows Server 2008, Windows Server 2008 R2, Windows Server 2012

Product/Feature

DNS

Severity

Critical

Category

Operation

Valid network interfaces should precede invalid interfaces in the binding order. A disabled or invalid adapter precedes a valid adapter in the network interface binding order list.

The binding order determines when network interfaces will be used to make network connections by the computer. A disabled adapter high in the binding order can degrade performance.

Move all disabled and invalid interfaces to the bottom of the binding order list.

Configure the binding order so that the primary network interface used to communicate with DNS clients is first in the list. Configure interfaces that connect to secondary or backup networks lower in the binding order. Move all disabled or invalid interfaces to the bottom of the binding order, or remove them from the list.

  1. Click Start, click Network, click Network and Sharing Center, and then click Manage Network Connections.

  2. Press the ALT key, click Advanced, and then click Advanced Settings. If you are prompted for an administrator password or confirmation, type the password or provide confirmation.

  3. Click the Adapters and Bindings tab, and then, under Connections, click the connection you want to modify.

  4. Under Bindings for <connection name>, select the protocol that you want to move up or down in the list, click the up or down arrow button, and then click OK.

Was this page helpful?
(1500 characters remaining)
Thank you for your feedback

Community Additions

ADD
Show:
© 2014 Microsoft