Share via


IPv6 - General

Applies To: Windows 7, Windows Server 2008 R2

RRAS uses a routing interface to forward unicast and multicast IP packets. There are two types of routing interfaces. Each available interface is displayed in the General pane, along with its type, assigned IP address, the amount of network traffic through it, and status information. To add an interface that is not currently listed, right-click General, and then click New Interface.

  • LAN interfaces. A LAN interface is a physical interface that typically represents a local area connection that uses local area networking technology such as Ethernet or token ring. A LAN interface reflects an installed network adapter. An installed WAN adapter is sometimes represented as a LAN interface. For example, some Frame Relay adapters create a separate logical LAN interface for each configured virtual circuit. LAN interfaces are always active and typically do not require an authentication process to become active.

  • Demand-dial interfaces. A demand-dial interface is a logical interface that represents a point-to-point connection. The point-to-point connection is based on either a physical connection, such as two routers connected over an analog phone line that uses modems, or a logical connection, such as two routers connected over a virtual private network (VPN) connection that uses the Internet. Demand-dial connections are either on-demand (the point-to-point connection is only established when needed) or persistent (the point-to-point connection is established and then remains in a connected state). Demand-dial interfaces typically require an authentication process to become connected. The equipment required by a demand-dial interface is a port on a device.

To configure server-wide Internet Protocol version 6 (IPv6) properties, under IPv6, right-click General, and then click Properties to display the IPv6 – General – Properties page.

To configure IPv6 properties for an individual interface, under IPv6, click General. In the details pane, right-click the interface you want to configure, and then click Properties to display the IPv6 – General – Interface – Properties page.

Additional references