Configure the Recording Idle Time-Out Value
Applies to: Exchange Server 2013, Exchange Online
Topic Last Modified: 2012-11-11
You can specify the number of seconds of silence that the system allows when a voice message is being recorded before the call is ended. For most organizations, this value should be set to the default of 5 seconds.
This value can be set from 2 through 10. Setting this value too low can cause the system to disconnect callers before they've finished leaving their voice messages. Setting this value too high allows lengthy silences in voice messages.
For additional management tasks related to UM dial plans, see UM Dial Plan Procedures.
Estimated time to complete: Less than 1 minute.
You need to be assigned permissions before you can perform this procedure or procedures. To see what permissions you need, see the "UM dial plans" entry in the Unified Messaging Permissions topic.
Before you perform these procedures, confirm that a UM dial plan has been created. For detailed steps, see Create a UM Dial Plan.
For information about keyboard shortcuts that may apply to the procedures in this topic, see Keyboard Shortcuts in the Exchange Admin Center.
In the EAC, navigate to Unified Messaging > UM dial plans.
In the list view, select the UM dial plan you want to modify, and then click Edit .
On the UM dial plan page, click Configure.
In Settings, under Recording idle time out (seconds), enter the number in seconds.
This example sets the recording idle time-out value to 10 for a UM dial plan named
Set-UMDialPlan -identity MyUMDialPlan -RecordingIdleTimeout 10