Export (0) Print
Expand All

Configure a Fully Qualified Domain Name

 

Applies to: Exchange Server 2013, Exchange Online

Topic Last Modified: 2012-11-09

You can configure a Unified Messaging (UM) IP gateway with either an IP address or a fully qualified domain name (FQDN). When you create a UM IP gateway, you must define the IP address or the FQDN configured on the VoIP gateway, IP PBX, or session border controller (SBC) that you're using. You can change the IP address or FQDN after the UM IP gateway is created.

If you create a UM IP gateway using an FQDN, you must create the appropriate HOST (A) records in your DNS forward lookup zone. If you create a UM IP gateway using an FQDN, and the DNS configuration for the UM IP gateway is changed, you must disable and then enable the UM IP gateway to make sure that its configuration information is updated correctly.

If you want to use mutual Transport Layer Security (mutual TLS) between a UM IP gateway and a dial plan operating in either SIP secured or Secured mode, you must configure the UM IP gateway with an FQDN. You must also configure it to listen on port 5061 and verify that the VoIP gateway, IP PBX, or SBC has also been configured to listen for mutual TLS requests on port 5061. To configure a UM IP gateway, run the following command: Set-UMIPGateway -identity MyUMIPGateway -Port 5061.

For additional management tasks related to UM IP gateways, see UM IP Gateway Procedures.

  • Estimated time to complete: 2 minutes.
  • You need to be assigned permissions before you can perform this procedure or procedures. To see what permissions you need, see the "UM IP gateways" entry in the Unified Messaging Permissions topic.
  • Before you perform these procedures, confirm that a UM dial plan has been created. For detailed steps, see Create a UM Dial Plan.
  • Before you perform these procedures, confirm that a UM IP gateway has been created. For detailed steps, see Create a UM IP Gateway.
  • For information about keyboard shortcuts that may apply to the procedures in this topic, see Keyboard Shortcuts in the Exchange Admin Center.
tipTip:
Having problems? Ask for help in the Exchange forums. Visit the forums at: Exchange Server, Exchange Online, or Exchange Online Protection.

  1. In the EAC, navigate to Unified Messaging > UM IP Gateways, select the UM IP gateway that you want to modify, and then click Edit Edit Icon.
  2. On the UM IP gateway page, in Address, enter the FQDN for the VoIP gateway, PBX enabled for SIP, IP PBX, or SBC.
  3. Click Save.
importantImportant:
When you use an FQDN instead of an IP address on the UM IP gateway, verify that the correct DNS records have been created.

This example configures a UM IP gateway named MyUMIPGateway with an FQDN named voipgateway.contoso.com.

Set-UMIPGateway -Identity MyUMIPGateway -Address voipgateway.contoso.com

This example configures a UM IP gateway named MySBC with an FQDN of sbc.contoso.com and listens for SIP requests on TCP port 5061.

Set-UMIPGateway -Identity MySBC -Address sbc.contoso.com -Port 5061
 
Was this page helpful?
(1500 characters remaining)
Thank you for your feedback
Show:
© 2014 Microsoft