Export (0) Print
Expand All
Expand Minimize

DHCP: The server should have at least one IPv4 scope

Updated: February 15, 2010

Applies To: Windows Server 2008 R2, Windows Server 2012

This topic is intended to address a specific issue identified by a Best Practices Analyzer scan. You should apply the information in this topic only to computers that have had the Dynamic Host Configuration Protocol Best Practices Analyzer run against them and are experiencing the issue addressed by this topic. For more information about best practices and scans, see Best Practices Analyzer (http://go.microsoft.com/fwlink/?LinkId=122786).

 

Operating System

Windows Server 2008 R2, Windows Server 2012

Product/Feature

Dynamic Host Configuration Protocol (DHCP)

Severity

Error

Category

Configuration

DHCP server does not have an IPv4 scope configured.

The DHCPv4 server will not lease IP addresses to DHCP clients unless a scope is configured.

Configure an IPv4 scope using the DHCP MMC.

A Dynamic Host Configuration Protocol (DHCP) scope is the consecutive range of possible IP addresses that the DHCP server can lease to clients on a subnet. Scopes typically define a single physical subnet on your network to which DHCP services are offered. Scopes are the primary way for the DHCP server to manage distribution and assignment of IP addresses and any related configuration parameters to DHCP clients on the network. Before a DHCP server can distribute addresses and options to clients, it must have an active scope.

Membership in the Administrators or DHCP Administrators group is the minimum required to complete this procedure.

  1. Click Start, point to Administrative Tools and then click DHCP.

  2. In the console tree, click the applicable DHCP server, right-click IPv4 and then click New Scope…

  3. Follow the instructions in the New Scope Wizard.

  1. Click Start, point to Administrative Tools and then click DHCP.

  2. In the console tree, click the applicable DHCP server, right-click IPv4, right click the applicable scope and then click Activate

noteNote
The Action menu command changes to Deactivate when the selected scope is currently activated. Do not deactivate a scope unless you are retiring it permanently from use on your network.

For updated detailed IT pro information about DHCP and selectively enabling or disabling DHCP server bindings, see the Windows Server 2008 R2 documentation on the Microsoft TechNet Web site.

Was this page helpful?
(1500 characters remaining)
Thank you for your feedback

Community Additions

ADD
Show:
© 2014 Microsoft