Export (0) Print
Expand All

Using the command prompt for Groove Server Relay

Groove Server 2010
 

Applies to: Groove Server 2010

Topic Last Modified: 2010-02-16

This article describes how to use the Windows command prompt for Groove Server Relay.

This procedure requires that the following conditions are met:

To use Relay command line entries
  1. From your Groove Server Relay computer, open a Windows command prompt from the Start menu.

  2. If you are not already running the Relay server as Administrator, type run as administrator, and then press Enter.

  3. To access information about Relay server command line entries, open a Windows command prompt, navigate to the Relay server installation directory, and then type: relay –h, and then press the Enter key.

    To find version information for the Groove Server Relay executable, open the Relay server installation directory, type relay –v, and then press the Enter key.

Was this page helpful?
(1500 characters remaining)
Thank you for your feedback
Show:
© 2014 Microsoft