Export (0) Print
Expand All
Expand Minimize

DFS-R: Replicated folder must be enabled for replication

Published: April 27, 2010

Updated: April 27, 2010

Applies To: Windows Server 2008 R2, Windows Server 2012

This topic is intended to address a specific issue identified by a Best Practices Analyzer scan. You should apply the information in this topic only to computers that have had the File Services Best Practices Analyzer run against them and are experiencing the issue addressed by this topic. For more information about best practices and scans, see Best Practices Analyzer.

 

Operating System

Windows Server 2008 R2

Product/Feature

File Services

Severity

Error

Category

Configuration

Replication has been disabled for the replicated folder '{0}' that belongs to replication group '{1}'.

Changes made to the data will not be replicated to or from the server '{2}'. As a result, the contents of the replicated folder '{0}' may become stale.

Use DFS Management to enable the replicated folder '{0}' that belongs to replication group '{1}' on '{2}'.

To enable replication for the replicated folder, use the following procedure:

  1. Click Start, point to Administrative Tools, and then click DFS Management.

  2. In the console tree, under the Replication node, click the replication group that contains the membership that you want to enable.

  3. In the details pane, click the Memberships tab.

  4. Right-click the replicated folder for the specific member and then click Enable.

noteNote
Membership changes are not applied immediately. The membership changes must be replicated to all domain controllers, and the member must poll its closest domain controller to obtain the changes. The amount of time this takes depends on AD DS replication latency and the short polling interval (5 minutes) on the member.

Was this page helpful?
(1500 characters remaining)
Thank you for your feedback

Community Additions

ADD
Show:
© 2014 Microsoft