Export (0) Print
Expand All

Global Media Bypass Options

 

Topic Last Modified: 2012-10-18

noteNote:
This topic assumes that you have already configured media bypass for any trunks to a peer (a PSTN gateway, an IP-PBX, or a Session Border Controller at an Internet Telephony Service Provider) for a specific site or service for which you want media to bypass the Mediation Server.

In addition to enabling media bypass for individual trunk connections associated with a peer, you must also enable media bypass globally. Global media bypass settings can either specify that media bypass is always attempted for calls to the PSTN or that media bypass is employed using the mapping of subnets to network sites and network regions, similar to what is done by call admission control, another advanced Voice feature. When media bypass and call admission control are both enabled, then the network region, network site, and subnet information that is specified for call admission control is automatically used when determining whether or not to employ media bypass. Meaning, you cannot specify the media bypass is always attempted for calls to the PSTN when call admission control is enabled.

This topic describes how to use Lync Server Control Panel and Lync Server Management Shell together to configure global media bypass settings.

noteNote:
When you use these steps to configure media bypass, the assumption is that you have good connectivity between clients and the Mediation Server peer (for example, a PSTN gateway, an IP-PBX, or an SBC at a SIP trunking provider). If there are any bandwidth limitations on the link, media bypass cannot be applied to the call. Media bypass will not interoperate with every PSTN gateway, IP-PBX, and SBC. Microsoft has tested a set of PSTN gateways with certified partners and has done some testing with Cisco IP-PBXs. Certification for SBCs is underway. Media bypass is supported only with products and versions listed on Unified Communications Open Interoperability Program – Lync Server at http://go.microsoft.com/fwlink/p/?LinkId=214406.

After you have enabled media bypass on any trunk connections to a peer for specific sites or services, use the following content to either:

 
Was this page helpful?
(1500 characters remaining)
Thank you for your feedback
Show:
© 2014 Microsoft