Get-NetNeighbor

Gets neighbor cache information only about a specific IP address family. The acceptable values for this parameter are:

-- IPv4: IPv4 Address information.

-- IPv6: IPv6 address information.

ps_cimcommon_asjob

Gets neighbor cache information only about a specific network IP interface CIM object. This is typically as input through the pipeline.

Runs the cmdlet in a remote session or on a remote computer. Enter a computer name or a session object, such as the output of a New-CimSessionhttp://go.microsoft.com/fwlink/p/?LinkId=227967 or Get-CimSessionhttp://go.microsoft.com/fwlink/p/?LinkId=227966 cmdlet. The default is the current session on the local computer.

Gets neighbor cache information only about a specific interface, as defined by the InterfaceAlias.

Gets neighbor cache information only about a specific interface, as defined by the InterfaceIndex number.

Gets neighbor cache information only about a specific neighbor IP address.

Specifies the link layer address of the neighbor cache entry. This is also known as a MAC address. A link-layer address that uses IPv4 address syntax is a tunnel technology that encapsulates packets over an IPv4 tunnel, such as ISATAP or Teredo. A link-layer address of all zeroes indicates that the neighbor is unreachable and the neighbor cache entry does not have a link-layer address entry. An empty link-layer address indicates that the link layer does not use link-layer addresses, such as on a loopback interface.

Specifies the PolicyStore value. The acceptable values for this parameter are:

-- ActiveStore: The IP address information is currently valid.

-- PersistentStore: The IP address information is persistent across reboots. When the computer starts, the PersistentStore settings are copied to the ActiveStore.

The default value is ActiveStore.

Gets neighbor cache information only about a specific state. The Neighbor Cache contains information maintained by Neighbor Unreachability Detection. A key piece of information is the reachability state of a neighbor. The acceptable values for this parameter are:

-- Unreachable: The IP address is unreachable.

-- Incomplete: Address resolution is in progress and the link-layer address of the neighbor has not yet been determined.

-- Probe: The neighbor is no longer known to be reachable, and unicast Neighbor Solicitation probes are being sent to verify reachability.

-- Delay: The neighbor is no longer known to be reachable, and traffic has recently been sent to the neighbor. Rather than probe the neighbor immediately, however, the system will delay sending probes for a short while in order to give upper layer protocols a chance to provide reachability confirmation.

-- Stale: The neighbor is no longer known to be reachable but until traffic is sent to the neighbor, no attempt should be made to verify its reachability.

-- Reachable: The neighbor is known to have been reachable recently (within tens of seconds).

-- Permanent: The neighbor is statically provisioned and will not expire unless deleted through configuration.

-- Maximum: A maximum value for testing purposes.

Specifies the maximum number of concurrent operations that can be established to run the cmdlet. If this parameter is omitted or a value of 0 is entered, then Windows PowerShell® calculates an optimum throttle limit for the cmdlet based on the number of CIM cmdlets that are running on the computer. The throttle limit applies only to the current cmdlet, not to the session or to the computer.