Export (0) Print
Expand All
1 out of 4 rated this helpful - Rate this topic

iSCSI Target Boot Overview

Published: February 29, 2012

Updated: February 29, 2012

Applies To: Windows Server 2012, Windows Storage Server 2012



iSCSI Target Server in Windows Server 2012 can boot hundreds of computers from a single operating system image that is stored in a centralized location. This improves efficiency, manageability, availability, and security.

By using differencing virtual hard disks (VHDs), you can use a single operating system image (the “master image”) to boot up to 256 computers. As an example, let’s assume that you deployed Windows Server 2008 R2 HPC with an operating system image of approximately 20 GB, and you used two mirrored disk drives to act as the boot volume. You would have needed approximately 10 TB of storage for only the operating system image to boot 256 computers. With iSCSI Target Server, you will use 40 GB for the operating system base image, and 2 GB for differencing virtual hard disks per server instance, totaling 552 GB for the operating system images. This provides a savings of over 90% on storage for the operating system images alone.

Using a controlled operating system image provides the following benefits:

More secure and easier to manage. Some enterprises require that data be secured by physically locking storage in a centralized location. In this scenario, servers access the data remotely, including the operating system image. With iSCSI Target Server, administrators can centrally manage the operating system boot images, and control which applications to use for the master image.

Rapid deployment. Because the master image is prepared by using Sysprep, when computers boot from the master image, they skip the file copying and installation phase that occurs during Windows Setup, and they go straight to the customization phase. In Microsoft internal testing, 256 computers were deployed in 34 minutes.

Fast recovery. Because the operating system images are hosted on the computer running iSCSI Target Server, if a diskless client needs to be replaced, the new computer can point to the operating system image, and boot up immediately.

noteNote
Various vendors provide a storage area network (SAN) boot solution, which can be used by the iSCSI Target Server in Windows Server 2012 on commodity hardware.

iSCSI Target Server does not require special hardware for functional verification. In data centers with large-scale deployments, the design should be validated against specific hardware. For reference, Microsoft internal testing indicated that a 256 computer deployment required 24x15k-RPM disks in a RAID 10 configuration for storage. A network bandwidth of 10 GB is optimal. A general estimate is 60 iSCSI boot servers per 1 GB network adapter.

A network adapter is not required for this scenario, and a software boot loader can be used (such as iPXE open source boot firmware).

iSCSI Target Server can be installed as part of the File and iSCSI Services role service in Server Manager.

For automation, you can use the corresponding Windows PowerShell cmdlets.

Did you find this helpful?
(1500 characters remaining)
Thank you for your feedback

Community Additions

ADD
Show:
© 2014 Microsoft. All rights reserved.