Deploying Forefront Identity Manager 2010 R2 Reporting
Deploying Forefront Identity Manager 2010 R2 - Reporting
This section provides information and step-by-step instructions on installing the various components that make up a Forefront Identity Manager 2010 R2 Reporting.
The following topic areas are covered in this section:
There are some several steps involved in getting FIM 2010 R2 Reporting installed and working. Some of these steps take some significant amount of time. However, these steps are dependent upon one another and you shouldn’t proceed to the next step until you have verified the previous step has completed. Use the following table below as a guide while deploying FIM 2010 R2 Reporting. The table also provides links to the sections that explain these steps in more detail.
| Step | Link |
|---|---|
Verify the initial Data Warehouse Schema has been created and SCSM is setup correctly |
See Registering with the Service Manager 2010 SP1 Data Warehouse to Enable Reporting |
Perform Environmental Pre-requisites |
|
Install FIM R2 2010 Reporting |
|
Ensure that MPSynch has finished and FIM Management Packs are now visible in SCSM |
Post-installation and Configuration for FIM 2010 R2 Reporting |
Install Data Warehouse Support Scripts |
Post-installation and Configuration for FIM 2010 R2 Reporting |
Run Start-FIMReportingInitialSync PowerShell Cmdlet |
Post-installation and Configuration for FIM 2010 R2 Reporting |
Run Start-FIMReportingIncrementalSync PowerShell Cmdlet |
Post-installation and Configuration for FIM 2010 R2 Reporting |
Run ETLScript PowerShell Script |
Post-installation and Configuration for FIM 2010 R2 Reporting |