Export (0) Print
Expand All

Deploying Forefront Identity Manager 2010 R2 Reporting

Deploying Forefront Identity Manager 2010 R2 - Reporting

This section provides information and step-by-step instructions on installing the various components that make up a Forefront Identity Manager 2010 R2 Reporting.

The following topic areas are covered in this section:

There are some several steps involved in getting FIM 2010 R2 Reporting installed and working. Some of these steps take some significant amount of time. However, these steps are dependent upon one another and you shouldn’t proceed to the next step until you have verified the previous step has completed. Use the following table below as a guide while deploying FIM 2010 R2 Reporting. The table also provides links to the sections that explain these steps in more detail.

 

Step Link

Verify the initial Data Warehouse Schema has been created and SCSM is setup correctly

See Registering with the Service Manager 2010 SP1 Data Warehouse to Enable Reporting

Perform Environmental Pre-requisites

Environmental Pre-requisites

Install FIM R2 2010 Reporting

Installing FIM 2010 R2 Reporting

Ensure that MPSynch has finished and FIM Management Packs are now visible in SCSM

Post-installation and Configuration for FIM 2010 R2 Reporting

Install Data Warehouse Support Scripts

Post-installation and Configuration for FIM 2010 R2 Reporting

Run Start-FIMReportingInitialSync PowerShell Cmdlet

Post-installation and Configuration for FIM 2010 R2 Reporting

Run Start-FIMReportingIncrementalSync PowerShell Cmdlet

Post-installation and Configuration for FIM 2010 R2 Reporting

Run ETLScript PowerShell Script

Post-installation and Configuration for FIM 2010 R2 Reporting

Was this page helpful?
(1500 characters remaining)
Thank you for your feedback
Show:
© 2014 Microsoft