Export (0) Print
Expand All

Set-WorkloadPolicy

 

Applies to: Exchange Server 2013

Topic Last Modified: 2014-03-05

This cmdlet is available only in on-premises Exchange Server 2013.

Use the Set-WorkloadPolicy cmdlet to modify the properties of a workload policy.

For information about the parameter sets in the Syntax section below, see Syntax.

Set-WorkloadPolicy -Identity <WorkloadPolicyIdParameter> -WorkloadClassification <Unknown | Discretionary | InternalMaintenance | CustomerExpectation | Urgent> [-Confirm [<SwitchParameter>]] [-DomainController <Fqdn>] [-WhatIf [<SwitchParameter>]]

This example decreases the priority of the PeopleRelevanceAssistant workload at the Contoso.com Dublin, Ireland location. Previously, Contoso.com created the custom workload policy DublinPeopleRelevanceAssistantWorkloadPolicy to set the classification of that workload to Discretionary. The classification of the PeopleRelevanceAssistant workload is being changed to InternalMaintenance.

Set-WorkloadPolicy -Identity DublinPeopleRelevanceAssistantWorkloadPolicy -WorkloadClassification InternalMaintenance

The Set-WorkloadPolicy cmdlet can be used to change the classification of an existing workload, the type of the workload, or the name. This cmdlet should not be used to modify the properties of workload policies that are marked Default, which are automatically installed by Exchange during setup.

You need to be assigned permissions before you can run this cmdlet. Although all parameters for this cmdlet are listed in this topic, you may not have access to some parameters if they're not included in the permissions assigned to you. To see what permissions you need, see the "Exchange workload throttling" entry in the Server health and performance permissions topic.

 

Parameter Required Type Description

Identity

Required

Microsoft.Exchange.Configuration.Tasks.WorkloadPolicyIdParameter

The Identity parameter specifies the name of the workload policy to modify.

WorkloadClassification

Required

Microsoft.Exchange.WorkloadManagement.WorkloadClassification

The WorkloadClassification parameter specifies the workload classification for a workload. You must specify one of the following classes: Urgent, CustomerExpectation, InternalMaintenance, or Discretionary.

Confirm

Optional

System.Management.Automation.SwitchParameter

The Confirm switch causes the command to pause processing and requires you to acknowledge what the command will do before processing continues. You don't have to specify a value with the Confirm switch.

DomainController

Optional

Microsoft.Exchange.Data.Fqdn

The DomainController parameter specifies the fully qualified domain name (FQDN) of the domain controller that writes this configuration change to Active Directory.

WhatIf

Optional

System.Management.Automation.SwitchParameter

The WhatIf switch instructs the command to simulate the actions that it would take on the object. By using the WhatIf switch, you can view what changes would occur without having to apply any of those changes. You don't have to specify a value with the WhatIf switch.

To see the input types that this cmdlet accepts, see Cmdlet Input and Output Types. If the Input Type field for a cmdlet is blank, the cmdlet doesn’t accept input data.

To see the return types, which are also known as output types, that this cmdlet accepts, see Cmdlet Input and Output Types. If the Output Type field is blank, the cmdlet doesn’t return data.

 
Was this page helpful?
(1500 characters remaining)
Thank you for your feedback
Show:
© 2014 Microsoft