Share via


Web Application Proxy: A cluster of Web Application Proxy servers is deployed and DirectAccess is also installed

 

Applies To: Windows Server 2012 R2

This topic is intended to address a specific issue identified by a Best Practices Analyzer scan. You should apply the information in this topic only to computers that have had the Web Application Proxy Best Practices Analyzer run against them and are experiencing the issue addressed by this topic. For more information about best practices and scans, see Best Practices Analyzer.

Operating System

Windows Server 2012 R2

Product/Feature

Web Application Proxy

Severity

Warning

Category

Configuration

Issue

A cluster of Web Application Proxy servers is deployed and DirectAccess is also installed on this server.

Impact

Web Application Proxy does not support this configuration and might not work as expected.

Resolution

Consider uninstalling DirectAccess from this server.

When Web Application Proxy is deployed in a multiple server deployment, it cannot be deployed on a server that also has DirectAccess installed. You must uninstall either DirectAccess, or Web Application Proxy. The following table shows the supported deployments:

DirectAccess

VPN

Web Application Proxy

Single server deployment

Single server deployment

Single server deployment

Multisite deployment

Multiple server deployment

Not supported on the same server

Not supported on the same server

Multiple server deployment

Multiple server deployment

Cluster deployment1

Multiple server deployment

Multiple server deployment2

Note

1—In a pre-existing DirectAccess cluster deployment, you can install Web Application Proxy only using Windows PowerShell. 2—In a pre-existing multiple server Web Application Proxy deployment, you can install DirectAccess only using Windows PowerShell.

Membership in the local Administrators group, or equivalent, is the minimum required to complete this procedure.

To uninstall DirectAccess

  1. On the Web Application Proxy server, open the Remote Access Management console: On the Start screen, click the Apps arrow. On the Apps screen, type RAMgmtUI.exe, and then press ENTER. If the User Account Control dialog box appears, confirm that the action it displays is what you want, and then click Yes.

  2. In the Remote Access Management console, in the navigation pane, click DirectAccess and VPN.

  3. In the Tasks pane, click Remove Configuration Settings.

  4. On the Confirm Remove Configuration dialog, click OK.

  5. On the Removing Configuration Settings dialog, make sure the configuration was removed, and then click Close.