Share via


Event ID 30024 — RRAS DHCP Relay Agent Packet Discarding

Applies To: Windows Server 2008

The DHCP Relay Agent is a Bootstrap Protocol (BOOTP) relay agent that relays Dynamic Host Configuration Protocol (DHCP) messages between DHCP clients and DHCP servers on different IP networks. For each IP network segment that contains DHCP clients, either a DHCP server or a computer acting as a DHCP Relay Agent is required.

If the DHCP Relay Agent (IPBOOTP) is discarding packets, DHCP configuration with peer clients and servers might fail.

Event Details

Product: Windows Operating System
ID: 30024
Source: Microsoft-Windows-RasIpBootp
Version: 6.0
Symbolic Name: IPBOOTPLOG_PACKET_OPCODE_INVALID
Message: IPBOOTP received a packet containing an invalid op-code. The packet has been discarded. It was received on the local interface with IP address: %1, and it came from a machine with IP address: %2.

Resolve

Check memory status, reinstall DHCP Relay Agent, or configure DHCP Relay Agent hop count

Possible resolutions:

  • This computer might be low on memory. For more information, see the "Check memory usage on the server" section.
  • Remove and reinstall the DHCP Relay Agent. For more information, see the "Remove and reinstall the DHCP Relay Agent" section.
  • Check that the hop count field is correctly configured. For more information, see the "Configure DHCP Relay Agent hop count" section.

To perform these procedures, you must have membership in Administrators, or you must have been delegated the appropriate authority.

Check memory usage on the server

To check memory usage on the remote access server:

  1. On the remote access server, click Start, click Run, type taskmgr, and then click OK.
  2. In the Windows Task Manager dialog box, click the Performance tab.
  3. Under Physical Memory, check the remote access server's memory usage.
  4. If necessary, free up available memory by ending non-essential applications or processes.

Remove and reinstall DHCP Relay Agent

To remove and add the DHCP Relay Agent:

  1. Open Routing and Remote Access. Click Start, click Run, type rrasmgmt.msc, and then press ENTER.
  2. In the console tree, expand IPv4, right-click DHCP Relay Agent, and then click Delete.
  3. Click Yes to confirm the deletion.
  4. Under IPv4, right-click General, and then click New Routing Protocol.
  5. Click DHCP Relay Agent, and then click OK.

Configure DHCP Relay Agent hop count

To configure DHCP Relay Agent hop count:

  1. Open Routing and Remote Access. Click Start, click Run, type rrasmgmt.msc, and then press ENTER.
  2. In the console tree, expand IPv4, and then click DHCP Relay Agent.
  3. In the details pane, right-click the interface you want to configure, and then click Properties.
  4. Check the settings in the Hop-count threshold field.

Verify

To verify that the DHCP Relay Agent is working:

From the router with the DHCP Relay Agent enabled, use the ping command to ping each of the DHCP servers that are configured in the DHCP Relay Agent dialog box on the remote access server.

RRAS DHCP Relay Agent Packet Discarding

Routing and Remote Access Service Infrastructure