Share via


Dialog Box - Add or Edit IPv4 Filter

Applies To: Windows 7, Windows Server 2008 R2

Use this dialog box to configure a filter that allows or blocks network traffic that matches a specified address or protocol.

Dialog box element Description

Source network

Select this option to specify that the filter checks the network from which the packet is coming. You must also specify an Internet Protocol version 4 (IPv4) network address and subnet mask.

Destination network

Select this option to specify that the filter checks the network to which the packet is sent. You must also specify an IPv4 network address and subnet mask.

IP address

The IP address of the network from which the packet was sent or to which the packet is going. You must also specify a subnet mask.

Subnet mask

The subnet mask that corresponds to the network IP address.

Protocol

Lists the available protocol types that you can base a filter on. The default is Any protocol. If you select Other, you must type a protocol identifier in Protocol number.

Source port

For TCP, TCP (established), and UDP protocols, provides a space for you to type the port number specified by the source to be used by the filter. Some applications use well-known ports to send and receive packets. You can set a filter for one of these ports if you know which numbers the application uses for the protocol specified in Protocol. For example, you can try to block FTP traffic or allow only PPTP traffic.

Destination port

For TCP, TCP (established), and UDP protocols, type the port number used by the destination for the packet.

ICMP type

For the ICMP protocol, type the ICMP type number.

ICMP code

For the ICMP protocol, type the ICMP code number.

Protocol number

For the Other protocol, type the IP protocol number.

Additional references