Share via


Event ID 2202 — DNS Server Configuration

Applies To: Windows Server 2008

The DNS server configuration consists of the settings that determine how the DNS server will function on a network and how those settings are stored and retrieved when they are needed.

 

Event Details

Product: Windows Operating System
ID: 2202
Source: Microsoft-Windows-DNS-Server-Service
Version: 6.0
Symbolic Name: DNS_EVENT_REGISTRY_WRITE_FAILED
Message: The DNS server could not write a registry key. The server disk could be full or corrupted or the maximum permissible size for the server registry has been reached. The DNS server will not be able to save server or zone configuration parameters to in the registry unless the problem is fixed.

Resolve

Correct the registry access problem

Check the following conditions:

  • Ensure that the server system disk is not full or corrupted.
  • Ensure that the registry has not reached the maximum allowed size.
  • Ensure that the registry is not corrupted.

If any of these conditions exists, the DNS server cannot update configuration data in the registry until the problem is fixed.

Verify

To verify that the Domain Name System (DNS) configuration is correct, verify that all configuration settings are correct, check the event log for events that indicate continuing problems, and then verify that DNS client computers are able to resolve names properly.

To verify DNS configuration settings:

  1. On the DNS server, start Server Manager. To start Server Manager, click Start, click Administrative Tools, and then click Server Manager.
  2. In the console tree, double-click Roles, double-click DNS Server, and then double-click DNS.
  3. Right-click the DNS server, and then click Properties.
  4. Review the settings on each tab, and verify that they contain the intended values.
  5. Expand the DNS server.
  6. Expand a zone folder, right-click a zone, and then click Properties.
  7. Review the settings on each tab, and verify that they contain the intended values.
  8. Repeat steps 6 and 7 for each zone.

To verify that DNS client computers can resolve names properly:

  1. On a DNS client computer, open a command prompt. To open a command prompt, click Start, click Run, type cmd, and then click OK.
  2. At the command prompt, type pinghostname (where hostname is the DNS name of a computer with a known IP address), and then press ENTER.

If the client can resolve the name, the ping command responds with the following message:

Pinginghostname [ip_address]

Note: The name resolution is successful even if the ping command reports that the destination is unreachable.

If the client cannot resolve the name, the ping command responds with the following message:

Ping request could not find hosthostname

DNS Server Configuration

DNS Infrastructure