Share via


DHCP: Credentials for DNS update should be configured if secure dynamic DNS update is enabled and the domain controller is on the same host as the DHCP server

Applies To: Windows Server 2008 R2, Windows Server 2012

This topic is intended to address a specific issue identified by a Best Practices Analyzer scan. You should apply the information in this topic only to computers that have had the Dynamic Host Configuration Protocol Best Practices Analyzer run against them and are experiencing the issue addressed by this topic. For more information about best practices and scans, see Best Practices Analyzer (https://go.microsoft.com/fwlink/?LinkId=122786).

Operating System

Windows Server 2008 R2, Windows Server 2012

Product/Feature

Dynamic Host Configuration Protocol (DHCP)

Severity

Error

Category

Configuration

Issue

Secure dynamic DNS update has been configured and a domain controller is running on the same host as the DHCP server, but credentials for DNS update have not been configured.

Impact

If credentials for DNS update are not configured, DNS registrations will fail.

Resolution

Using the DHCP MMC, configure IPv4 and IPv6 with credentials for dynamic DNS update.

A DHCP server can enable dynamic updates in the DNS namespace for any one of its clients that support these updates. Scope clients can use the DNS dynamic update protocol to update their host name-to-address mapping information whenever changes occur to their DHCP-assigned address. (This mapping information is stored in zones on the DNS server.) A DHCP server can perform updates on behalf of its DHCP clients to any DNS server, but it must first supply proper credentials.

Membership in the Administrators or DHCP Administrators group is the minimum required to complete this procedure.

To configure credentials for dynamic DNS update

  1. Click Start, point to Administrative Tools and then click DHCP.

  2. In the console tree, right-clickIPv4, and then click Properties

  3. Click Advanced, click Credentials, type the credentials that the DHCP server supplies when registering names using DNS dynamic updates, and then click OK.

Additional references

For updated detailed IT pro information about DNS and DHCP, see the Windows Server 2008 R2 documentation on the Microsoft TechNet Web site.