Upgrading Device Manager 2011 Client

  • Article

5/4/2012

This section provides instructions for upgrading Device Manager 2011 client on a device. For more information about upgrade installer file names, see the table in Device Manager 2011 Client Installation.

The following procedure, with the exception of creating an advertisement, references the tasks in Tasks for Software Distribution (in Configuration Manager Help) with a few modifications, specific to Device Manager 2011.

To upgrade Device Manager 2011 client on a device

  1. Create a package. For more information, see How to Create a Package in Configuration Manager Help.

  2. Create a program by using the following settings in the New Program Wizard. For more information, see How to Create a Program in Configuration Manager Help.

    1. On the General page, in the Command Line box enter the following command:
      msiexec /p <file name> /qn /norestart /lv <LogFilename>.log
    2. On the General page, in the After running box, select ConfigMgr restarts computer.
    3. On the Environment page, in the Program can run list, select Whether or not a user is logged on.
    4. On the Environment page, in the Run Mode box, select Run with administrative rights.

  3. Send a package to distribution points. For more information, see How to Send a Package to Distribution Points in Configuration Manager Help.

  4. Create an advertisement. Before you begin to create an advertisement, make sure that you have the appropriate permissions to perform the task. For more information, see Managing Security Using Device Manager 2011. If write filters are not installed on a device, the advertisement will install new software and ignore the commands to disable and restore write filters.

    Note

    Device Manager 2011 restarts devices from the operating system every time that the write filters are disabled and restored. Depending on how you have scheduled the software deployment, there may be pauses during this process.

    Use the following steps to create an advertisement with write filter support:

    1. Click System Center Configuration Manager, expand Computer Management, expand Embedded Device Management, and then expand Write Filter Servicing.
    2. Right-click Advertisements with Write Filter Handling and select New. This starts the New Advertisement with Write Filter Handling Wizard.
    3. On the first page of the New Advertisement with Write Filter Handling Wizard, select the following two check boxes:
      • To acknowledge that you want to disable write filters and that you realize the devices have to be restarted, select I understand that the devices will be restarted and the write filters will be temporarily disabled. Devices will be vulnerable to unattended persistent modifications as long as write filters are disabled and may lose data when restarted.
      • To allow unattended installation, select Package supports unattended installation. Users of the affected devices will be unable to log on during the servicing process.
    4. Click Next.
    5. Complete the rest of the wizard as you would the New Advertisement Wizard. For more information, see New Advertisement Wizard in Configuration Manager Help.

See Also

Concepts

Device Manager 2011 Client Installation