Was this page helpful?
Additional feedback?
1500 characters remaining
Export (0) Print
Expand All



Applies to: Exchange Online, Exchange Server 2016

This cmdlet is available in on-premises Exchange Server 2016 and in the cloud-based service. Some parameters and settings may be exclusive to one environment or the other.

Use the Disable-UMIPGateway cmdlet to disable a Unified Messaging (UM) IP gateway.

For information about the parameter sets in the Syntax section below, see Syntax.

Disable-UMIPGateway -Identity <UMIPGatewayIdParameter> [-Confirm [<SwitchParameter>]] [-DomainController <Fqdn>] [-Immediate <$true | $false>] [-WhatIf [<SwitchParameter>]]

This example disables the UM IP gateway MyUMIPGateway and stops it from accepting incoming calls from the IP gateway.

Disable-UMIPGateway -Identity MyUMIPGateway

This example disables the UM IP gateway MyUMIPGateway and disconnects all current calls immediately.

Disable-UMIPGateway -Identity MyUMIPGateway -Immediate $true

The status variable for a UM IP gateway can be used to enable or disable call answering destined for the IP gateway. The Disable-UMIPGateway cmdlet disables a UM IP gateway in Active Directory by modifying its status variable. After this task is completed, the UM IP gateway no longer answers incoming calls or makes outgoing calls.

You need to be assigned permissions before you can run this cmdlet. Although all parameters for this cmdlet are listed in this topic, you may not have access to some parameters if they're not included in the permissions assigned to you. To see what permissions you need, see the "UM IP gateways" entry in the Unified Messaging permissions topic.


Parameter Required Type Description




The Identity parameter specifies the identifier for the UM IP gateway being disabled. This is the directory object ID for the UM IP gateway.




The Confirm switch specifies whether to show or hide the confirmation prompt. How this switch affects the cmdlet depends on if the cmdlet requires confirmation before proceeding.

  • Destructive cmdlets (for example, Remove-* cmdlets) have a built-in pause that forces you to acknowledge the command before proceeding. For these cmdlets, you can skip the confirmation prompt by using this exact syntax: -Confirm:$false.

  • Most other cmdlets (for example, New-* and Set-* cmdlets) don't have a built-in pause. For these cmdlets, specifying the Confirm switch without a value introduces a pause that forces you acknowledge the command before proceeding.




This parameter is available only in on-premises Exchange 2016.

The DomainController parameter specifies the domain controller that's used by this cmdlet to read data from or write data to Active Directory. You identify the domain controller by its fully qualified domain name (FQDN). For example, dc01.contoso.com.




The Immediate parameter specifies whether the Mailbox server running the Microsoft Exchange Unified Messaging service drops incoming calls associated with this UM IP gateway immediately or waits for the current calls to finish processing.




The WhatIf switch simulates the actions of the command. You can use this switch to view the changes that would occur without actually applying those changes. You don't need to specify a value with this switch.

To see the input types that this cmdlet accepts, see Cmdlet Input and Output Types. If the Input Type field for a cmdlet is blank, the cmdlet doesn’t accept input data.

To see the return types, which are also known as output types, that this cmdlet accepts, see Cmdlet Input and Output Types. If the Output Type field is blank, the cmdlet doesn’t return data.

Was this page helpful?
(1500 characters remaining)
Thank you for your feedback
© 2015 Microsoft