Was this page helpful?
Additional feedback?
1500 characters remaining
Export (0) Print
Expand All

Netsh commands for Interface Teredo

Updated: February 8, 2008

Applies To: Windows Server 2008

This section contains the following commands

  • set state

  • show state

The following entries provide details for each command.

Sets the Teredo state. A default argument to a parameter sets it to the system default.


set state [ [ type= ] disabled | client | enterpriseclient | default ] [ [ servername= ] HostName | IPv4Address | default ] [ [ refreshinterval= ] Integer | default ] [ [ clientport= ] Integer | default ] [ [ supernode= ] HostName | IPv4Address | default ]


Optional. Specifies one of the following values: disabled: Disable the Teredo service. client: Enable the Teredo client. enterpriseclient: Skip managed network detection.

Optional. Specifies the Host Name or IPv4 address of the Teredo server.

Optional. Specifies an integer value for the client refresh interval (in seconds).

Optional. Specifies the integer that is the client's UDP port (if default is specified, this value is chosen by system).

Optional. Specifies the Super-Node to use when behind a firewall.


Following is an example of how to use the set state and ipv6 set interface commands to configure Teredo.

At the Teredo server configure two consecutive static IPv4 addresses on the same interface (i.e. - and and then: set state server

At the Teredo client: set state server

Enable forwarding between the Teredo interface and the native IPV6 interface with: int ipv6 set interface [interface id] forwarding=enabled

Shows the Teredo state.


show state

Was this page helpful?
(1500 characters remaining)
Thank you for your feedback

Community Additions

© 2015 Microsoft