Event ID 20182 — RRAS Routing Interfaces

Updated: November 29, 2007

Applies To: Windows Server 2008

red

The server running Routing and Remote Access uses a routing interface to forward unicast IP and multicast IP packets. There are two types of routing interfaces: LAN interfaces and demand-dial interfaces. A LAN interface is a physical interface that typically represents a local area connection that uses local area networking technology such as Ethernet or token ring. A demand-dial interface is a logical interface that represents a point-to-point connection. The point-to-point connection is based on either a physical connection, such as two routers connected over an analog phone line that uses modems, or a logical connection, such as two routers connected over a virtual private network (VPN) connection that uses the Internet.

Event Details

Product: Windows Operating System
ID: 20182
Source: RemoteAccess
Version: 6.0
Symbolic Name: ROUTERLOG_IF_UNREACHABLE_REASON4
Message: Interface: %1 is unreachable because the Routing and Remote Access service is in a paused state.

Resolve

Enable network devices or services

To perform thes procedures, you must be a member of the Administrators group, or you must have been delegated the appropriate authority.

Enable the network interface

To enable the network interface:

  1. Open Network Connections, and check the status of the network device.
  2. Right-click the network device, and then click Enable.

Start the Routing and Remote Access service

To start the Routing and Remote Access service:

  1. Open Routing and Remote Access. Click Start, click Run, type rrasmgmt.msc, and then press ENTER.
  2. In the console tree, click Server Status.
  3. In the details pane, right-click a server name, point to All Tasks, and click Start.

Verify

To verify that the remote access server can accept connections, establish a remote access connection from a client computer.

To create a VPN connection:

  1. Click Start, and then click Control Panel.
  2. Click Network and Internet, click Network and Sharing Center, and then click Set up a connection or network.
  3. Click Connect to a workplace, and then click Next.
  4. Complete the steps in the Connect to a Workplace wizard.

To connect to a remote access server:

  1. In Network and Sharing Center, click Manage network connections.
  2. Double-click the VPN connection, and then click Connect.
  3. Verify that the connection was established successfully.

Related Management Information

RRAS Routing Interfaces

Routing and Remote Access Service Infrastructure

Community Additions

ADD
Show: