Event ID 20106 — RRAS Routing Interfaces

Updated: November 29, 2007

Applies To: Windows Server 2008

red

The server running Routing and Remote Access uses a routing interface to forward unicast IP and multicast IP packets. There are two types of routing interfaces: LAN interfaces and demand-dial interfaces. A LAN interface is a physical interface that typically represents a local area connection that uses local area networking technology such as Ethernet or token ring. A demand-dial interface is a logical interface that represents a point-to-point connection. The point-to-point connection is based on either a physical connection, such as two routers connected over an analog phone line that uses modems, or a logical connection, such as two routers connected over a virtual private network (VPN) connection that uses the Internet.

Event Details

Product: Windows Operating System
ID: 20106
Source: RemoteAccess
Version: 6.0
Symbolic Name: ROUTERLOG_COULDNT_ADD_INTERFACE
Message: Unable to add the interface: %1 with the router manager for the %2 protocol. The following error occurred: %3

Resolve

Review the remote access service error code

There is not enough information available in the Routing and Remote Access service event message to provide a recommendation for the resolution of the problem. If you continue to get this error, contact Microsoft Product Support Services. For more information, see http://go.microsoft.com/fwlink/?LinkId=52267.

For more information about remote access service error codes, see article 163111 in the Microsoft Knowledge Base (http://go.microsoft.com/fwlink/?LinkID=91455).

Verify

To verify that the remote access server can accept connections, establish a remote access connection from a client computer.

To create a VPN connection:

  1. Click Start, and then click Control Panel.
  2. Click Network and Internet, click Network and Sharing Center, and then click Set up a connection or network.
  3. Click Connect to a workplace, and then click Next.
  4. Complete the steps in the Connect to a Workplace wizard.

To connect to a remote access server:

  1. In Network and Sharing Center, click Manage network connections.
  2. Double-click the VPN connection, and then click Connect.
  3. Verify that the connection was established successfully.

Related Management Information

RRAS Routing Interfaces

Routing and Remote Access Service Infrastructure

Community Additions

ADD
Show: