Share via


Configure remote access protocols for Macintosh clients

Applies To: Windows Server 2003, Windows Server 2003 R2, Windows Server 2003 with SP1, Windows Server 2003 with SP2

To configure remote access protocols for Macintosh clients

  1. Open Routing and Remote Access.

  2. Right-click the server name, click Configure and Enable Routing and Remote Access, and then follow directions in the Routing and Remote Access Server Setup Wizard.

  3. Click Remote access server.

  4. After the wizard finishes, open Routing and Remote Access again, and then right-click the server name.

  5. Click Properties, and then click the PPP tab to configure PPP settings.

Notes

  • To perform this procedure, you must be a member of the Administrators group. As a security best practice, consider using the Run As command rather than logging on with administrative credentials. If you have logged on with administrative credentials, you can also open Routing and Remote Access by clicking Start, clicking Control Panel, double-clicking Administrative Tools, and then double-clicking Routing and Remote Access. For more information, see Default local groups, Default groups, and Using Run as.

  • If you need to add the server, right-click Server Status, then click Add Server.

Information about functional differences

  • Your server might function differently based on the version and edition of the operating system that is installed, your account permissions, and your menu settings. For more information, see Viewing Help on the Web.

See Also

Concepts

Install the AppleTalk protocol and routing
Configure AppleTalk protocol
Remote Access