Share via


Event ID 30030 — RRAS Route Ignoring

Applies To: Windows Server 2008 R2

A Router Information Protocol (RIP) for IP environment automatically adds and removes routes as networks are added and removed from the network. If the router is ignoring route updates, route configuration with peer routers might fail.

Event Details

Product: Windows Operating System
ID: 30030
Source: Microsoft-Windows-RasRoutingProtocols-IPRIP2
Version: 6.1
Symbolic Name: IPRIPLOG_BROADCAST_ROUTE_INVALID
Message: IPRIPv2 is ignoring a route to the broadcast network: %1 with next-hop: %2 which was advertised by a neighbor with IP address: %3.

Resolve

Check RIP configuration

To perform this procedure, you must have membership in Administrators, or you must have been delegated the appropriate authority.

To configure Routing Information Protocol version 2 (RIPv2):

  1. Open Routing and Remote Access. Click Start, click Run, type rrasmgmt.msc, and then press ENTER.
  2. In the console tree, expand IPv4, and then click RIP.
  3. In the details pane, right-click the interface you want to configure, and then click Properties.
  4. Check the settings on the General, Security, Neighbors, and Advanced tabs.

 

Verify

To perform this procedure, you must have membership in Administrators, or you must have been delegated the appropriate authority.

To verify that the Routing Table Manager (RTM) route has been added:

  • Stop and restart the Routing and Remote Access service.
    1. Click Start, click Run, type rrasmgmt.msc, and then press ENTER.
    2. Open Routing and Remote Access.
    3. In the console tree, click Server Status.
    4. In the details pane, right-click a server name, point to All Tasks, and click Restart.
  • View the routing table. In the Routing and Remote Access snap-in, expand IPv4 or IPv6, right-click Static Routes, and then click Show IP Routing Table.
  • Verify that the route has been added.

RRAS Route Ignoring

Routing and Remote Access Service Infrastructure