Was this page helpful?
Your feedback about this content is important. Let us know what you think.
Additional feedback?
1500 characters remaining
Export (0) Print
Expand All
Collapse the table of content
Expand the table of content
Expand Minimize



Applies to: Exchange Server 2016

This cmdlet is available only in on-premises Exchange Server 2016.

Use the Remove-EcpVirtualDirectory cmdlet to remove Exchange Control Panel (ECP) virtual directories from Internet Information Services (IIS) on Exchange Microsoft servers. The ECP virtual directory manages the Exchange admin center.

The ECP web management interface was introduced in MicrosoftExchange Server 2010. In Exchange Server 2013 and Exchange Server 2016, the EAC virtual directories and the corresponding management cmdlets still use ECP in the name. You can use these cmdlets to manage ECP virtual directories on Exchange 2010, Exchange 2013, and Exchange 2016 servers.

For information about the parameter sets in the Syntax section below, see Syntax.

Remove-EcpVirtualDirectory -Identity <VirtualDirectoryIdParameter> [-Confirm [<SwitchParameter>]] [-DomainController <Fqdn>] [-WhatIf [<SwitchParameter>]]

This example removes the ECP virtual directory named ecp located on the default IIS website on the Exchange server named Server01.

Remove-EcpVirtualDirectory -Identity "Server01\ecp (Default Web site)"

You need to be assigned permissions before you can run this cmdlet. Although all parameters for this cmdlet are listed in this topic, you may not have access to some parameters if they're not included in the permissions assigned to you. To see what permissions you need, see the "Exchange admin center connectivity" entry in the Exchange infrastructure and PowerShell permissions topic.


Parameter Required Type Description




The Identity parameter specifies the virtual directory that you want to remove.

You can use any value that uniquely identifies the virtual directory. For example:

  • Name or <Server>\Name

  • Distinguished name (DN)

  • GUID

The Name value uses the syntax "<VirtualDirectoryName> (<WebsiteName>)" from the properties of the virtual directory. You can specify the wildcard character (*) instead of the default website by using the syntax <VirtualDirectoryName>*.

Remote removal of an ECP virtual directory isn't supported. You need run this command from the local computer.




The Confirm switch specifies whether to show or hide the confirmation prompt. How this switch affects the cmdlet depends on if the cmdlet requires confirmation before proceeding.

  • Destructive cmdlets (for example, Remove-* cmdlets) have a built-in pause that forces you to acknowledge the command before proceeding. For these cmdlets, you can skip the confirmation prompt by using this exact syntax: -Confirm:$false.

  • Most other cmdlets (for example, New-* and Set-* cmdlets) don't have a built-in pause. For these cmdlets, specifying the Confirm switch without a value introduces a pause that forces you acknowledge the command before proceeding.




The DomainController parameter specifies the domain controller that's used by this cmdlet to read data from or write data to Active Directory. You identify the domain controller by its fully qualified domain name (FQDN). For example, dc01.contoso.com.




The WhatIf switch simulates the actions of the command. You can use this switch to view the changes that would occur without actually applying those changes. You don't need to specify a value with this switch.

To see the input types that this cmdlet accepts, see Cmdlet Input and Output Types. If the Input Type field for a cmdlet is blank, the cmdlet doesn’t accept input data.

To see the return types, which are also known as output types, that this cmdlet accepts, see Cmdlet Input and Output Types. If the Output Type field is blank, the cmdlet doesn’t return data.

Was this page helpful?
(1500 characters remaining)
Thank you for your feedback
© 2015 Microsoft