Configure Media Bypass to Always Bypass the Mediation Server
Topic Last Modified: 2010-11-09
This topic assumes that you have already configured media bypass for any trunk connections to a peer (a PSTN gateway, an IP-PBX, or a Session Border Controller at an Internet Telephony Service Provider) for a specific site or service for which you want media to bypass the Mediation Server.|
You cannot configure media to always bypass the Mediation Server while also enabling call admission control. These settings are incompatible, and are therefore mutually exclusive settings in the Lync Server Control Panel user interface.
In addition to enabling media bypass for individual trunk connections associated with a peer to the Mediation Server, you must also configure global settings for media bypass. If you use the steps in this topic to configure global settings for media bypass, the assumption is that you have good connectivity between Microsoft Lync Server 2010 endpoints and any peer for which you configured media bypass on the trunk connection.
If you do not have good connectivity between Lync Server endpoints and all peers to the Mediation Server whose respective trunk connections have been enabled for media bypass, you must configure global media bypass settings to use site and region information when employing media bypass. This allows for more fine-grained control over when media bypasses the Mediation Server. To do this, use the steps in Configure Media Bypass Global Settings to Use Site and Region Information and Associate a Subnet with a Network Site instead.
Open a browser window, and then enter the Admin URL to open the Lync Server Control Panel. For details about the different methods you can use to start Lync Server Control Panel, see Open Lync Server Administrative Tools.
In the left navigation bar, click Network Configuration.
Double-click the Global configuration in the list.
On the Edit Global Setting page, select the Enable media bypass check box.
Click Always bypass.