Export (0) Print
Expand All

How to Run WinRM Commands on the Target Computer

 

Applies To: System Center 2012 - Unified Installer

When you run System Center 2012 – Unified Installer, the target computer where the components are being installed must have WinRM configured to accept fresh credentials and the computers involved in the installation must be added to the Trusted Host list.

Complete the following procedure on the target computer where you want to install a Service Manager 2012 component. This procedure shows you how to make these changes using WinRM commands.

System_CAPS_noteNote

Make sure that the Windows Remote Management Service is started on computers using Windows 7.

To use WinRM commands on the target computer

  1. Click Start, click All Programs, click Accessories, right-click Command Prompt, and then click Run as administrator.

  2. In the command prompt window, type the following command, and press Enter after each command:

    winrm qc -q
    winrm set winrm/config/service/auth @{CredSSP="True"}
    winrm set winrm/config/winrs @{AllowRemoteShellAccess="True"}
    winrm set winrm/config/winrs @{MaxMemoryPerShellMB="2048"}
    
  3. Type exit, and then press Enter.

Was this page helpful?
(1500 characters remaining)
Thank you for your feedback
Show:
© 2015 Microsoft