Was this page helpful?
Additional feedback?
1500 characters remaining
Export (0) Print
Expand All
Collapse the table of content
Expand the table of content
Expand Minimize



Applies to: Exchange Server 2016

This cmdlet is available only in on-premises Exchange Server 2016.

Use the Set-ResubmitRequest cmdlet to enable or disable requests to replay redundant copies of messages from Safety Net after a mailbox database recovery.

For information about the parameter sets in the Syntax section below, see Syntax.

Set-ResubmitRequest -Identity <ResubmitRequestIdentityParameter> -Enabled <$true | $false> [-Confirm [<SwitchParameter>]] [-Server <ServerIdParameter>] [-WhatIf [<SwitchParameter>]]

This example disables the resubmit request with the identity 8.

Set-ResubmitRequest 8 -Enabled $false

You need to be assigned permissions before you can run this cmdlet. Although all parameters for this cmdlet are listed in this topic, you may not have access to some parameters if they're not included in the permissions assigned to you. To see what permissions you need, see the "Queues" entry in the Mail flow permissions topic.


Parameter Required Type Description




The Enabled parameter enables or disables an active resubmit request. Valid input for this parameter is $true or $false. Setting the value to $false disables the resubmit request.




The Identity parameter specifies the resubmit request you want to modify. Each resubmit request is identified by an incremented integer value.




The Confirm switch specifies whether to show or hide the confirmation prompt. How this switch affects the cmdlet depends on if the cmdlet requires confirmation before proceeding.

  • Destructive cmdlets (for example, Remove-* cmdlets) have a built-in pause that forces you to acknowledge the command before proceeding. For these cmdlets, you can skip the confirmation prompt by using this exact syntax: -Confirm:$false.

  • Most other cmdlets (for example, New-* and Set-* cmdlets) don't have a built-in pause. For these cmdlets, specifying the Confirm switch without a value introduces a pause that forces you acknowledge the command before proceeding.




The Server parameter specifies the Exchange server where you want to run this command. You can use any value that uniquely identifies the server. For example:

  • Name

  • FQDN

  • Distinguished name (DN)

  • Exchange Legacy DN

If you don't use this parameter, the command is run on the local server.




The WhatIf switch simulates the actions of the command. You can use this switch to view the changes that would occur without actually applying those changes. You don't need to specify a value with this switch.

To see the input types that this cmdlet accepts, see Cmdlet Input and Output Types. If the Input Type field for a cmdlet is blank, the cmdlet doesn’t accept input data.

To see the return types, which are also known as output types, that this cmdlet accepts, see Cmdlet Input and Output Types. If the Output Type field is blank, the cmdlet doesn’t return data.

Was this page helpful?
(1500 characters remaining)
Thank you for your feedback
© 2015 Microsoft