Applies to: Exchange Server 2013

This cmdlet is available only in on-premises Exchange Server 2013.

Use the Remove-GlobalMonitoringOverride cmdlet to remove a managed availability global override that has been configured for a probe, monitor, or responder.

For information about the parameter sets in the Syntax section below, see Syntax.

Remove-GlobalMonitoringOverride -Identity <String> -ItemType <Probe | Monitor | Responder | Maintenance> -PropertyName <String> [-Confirm [<SwitchParameter>]] [-DomainController <Fqdn>] [-WhatIf [<SwitchParameter>]]

This example removes a global monitoring override of the ActiveDirectoryConnectivityConfigDCServerReboot responder in the Exchange health set.

Remove-GlobalMonitoringOverride -Identity Exchange\ActiveDirectoryConnectivityConfigDCServerReboot -ItemType Responder -PropertyName Enabled

This example removes a global monitoring override of the ExtensionAttributes property of the OnPremisesInboundProxy probe in the FrontEndTransport health set.

Remove-GlobalMonitoringOverride -Identity FrontEndTransport\OnPremisesInboundProxy -ItemType Probe -PropertyName ExtensionAttributes

You need to be assigned permissions before you can run this cmdlet. Although all parameters for this cmdlet are listed in this topic, you may not have access to some parameters if they're not included in the permissions assigned to you. To see what permissions you need, see the "Shell Infrastructure Permissions" section in the Exchange and Shell infrastructure permissions topic.


Parameter Required Type Description




The Identity parameter specifies the monitoring item that was overridden. The value is in the form of HealthSet\MonitoringItem, or HealthSet\MonitoringItem\TargetResource.




The ItemType parameter specifies the item type that you want to remove. It can be any of the following values:

  • Probe

  • Monitor

  • Responder




The PropertyName parameter specifies the property for the override you want to remove.




The Confirm switch causes the command to pause processing and requires you to acknowledge what the command will do before processing continues. You don't have to specify a value with the Confirm switch.




The DomainController parameter specifies the fully qualified domain name (FQDN) of the domain controller that writes this configuration change to Active Directory.

The DomainController parameter isn't supported on Edge Transport servers. An Edge Transport server uses the local instance of Active Directory Lightweight Directory Services (AD LDS) to read and write data.




The WhatIf switch instructs the command to simulate the actions that it would take on the object. By using the WhatIf switch, you can view what changes would occur without having to apply any of those changes. You don't have to specify a value with the WhatIf switch.

To see the input types that this cmdlet accepts, see Cmdlet Input and Output Types. If the Input Type field for a cmdlet is blank, the cmdlet doesn’t accept input data.

To see the return types, which are also known as output types, that this cmdlet accepts, see Cmdlet Input and Output Types. If the Output Type field is blank, the cmdlet doesn’t return data.