Share via


How to Configure Ports for POP3 Authentication

Microsoft Exchange Server 2007 will reach end of support on April 11, 2017. To stay supported, you will need to upgrade. For more information, see Resources to help you upgrade your Office 2007 servers and clients.

 

Applies to: Exchange Server 2007, Exchange Server 2007 SP1, Exchange Server 2007 SP2, Exchange Server 2007 SP3

This topic explains how to use the Exchange Management Shell to configure Exchange to use ports other than the default ports for POP3 authentication.

Note

After you have configured ports for POP3, you must restart the POP3 service. For more information about how to restart the POP3 service, see How to Start and Stop the POP3 Service.

Before You Begin

To perform the following procedures on a computer that has the POP3 service enabled, the account you use must be delegated the Exchange Server Administrators role and membership in the local Administrators group for the target server.

For more information about permissions, delegating roles, and the rights that are required to administer Exchange Server 2007, see Permission Considerations.

Procedure

To use the Exchange Management Shell to configure ports for POP3 authentication

  • To set the port to a value other than the default port number, run the following command:

    Set-PopSettings -UnencryptedOrTLSBindings IPaddress:Port
    

For more information about syntax and parameters, see Set-POPSettings.

For More Information

For more information about the default port values that you can use with the available authentication settings, see How to Configure Authentication for POP3.