Standard Sender Address Properties: General Tab

Aplica-se a: System Center Configuration Manager 2007, System Center Configuration Manager 2007 R2, System Center Configuration Manager 2007 R3, System Center Configuration Manager 2007 SP1, System Center Configuration Manager 2007 SP2

The standard sender general properties are used to specify the destination site of the sender address, the sender address's priority relative to other sender addresses to the same site, and information needed to access the destination site.

Destination site code
The site code for the site associated with this sender address. If this sender address already exists, this field is unavailable. If you are creating a new sender address, select a site from the list (which contains all known sites) or type a site code. Do not type a site name; it will be ignored.

Relative address priority
A priority to this sender address that is compared to any other sender addresses (such as for Courier Sender or Standard Sender) to the same site. A value of 1 is the highest priority.

The highest priority sender address is tried first when the current site communicates with this destination site. If this communication fails, the next-highest priority sender address is used.

When you create a new sender address, the default priority is the lowest available. For example, if there are two other sender addresses to the destination site on the current site, the default for this field is 3. Priority values cannot be shared; only one sender address can exist for each priority number.

Destination Access
The controls located within the Destination access group are used by the new address to define the destination site server and the account used to connect to it.

  • Site server name: Enter the site server name that this address will be used to connect to (can be either FQDN or shortname).

  • Site address account: By default, the originating site server computer account is used to connect to the destination site. If you prefer to use a domain user account for the address to use as the Site Address account to connect to the destination site server, you can click Set. However, after you enter a user account, you cannot change back to using the site server computer account without deleting the sender address and recreating it.

  • Set. Click to open the Windows User Account dialog box, which enables you to specify the destination access account.

Consulte Também

For additional information, see Configuration Manager 2007 Information and Support.
To contact the documentation team, email