本文件已封存並已停止維護。

How to Replace a Disk in the Storage Pool

更新日期: 2010年4月

適用於: System Center Data Protection Manager 2010

You can use the following procedure to replace a disk in the storage pool if a disk fails.

To replace a disk in the storage pool

  1. In the Disk Management console, identify the replica volumes and recovery point volumes that are stored on the failed disk.

  2. Remove protection from the data sources that have replica volumes and recovery point volumes on the failed disk, and select Delete protected data.

  3. Physically remove the disk that needs to be replaced.

  4. Physically add the replacement disk.

  5. In DPM Administrator Console, click Management on the navigation bar, and then click the Disks tab.

  6. Select the disk that you removed, and in the Actions pane, click Remove.

  7. In the Actions pane, click Add.

  8. In the Available disks section, select the replacement disk, click Add, and then click OK.

  9. Add the data sources from step 2 to an existing protection group, or create a new protection group for these data sources.

    1. If you create a new protection group and have tape backup of the data sources, create the replicas manually by using the tape backup.

    2. If you create a new protection group and do not have tape backup of the data sources, allow DPM to create the replicas across the network.

    3. If you add the data sources to an existing protection group, DPM will start an immediate consistency check, which will re-create the replicas.

    note附註
    For more information, in the TechNet Library, see Configuring DPM (http://go.microsoft.com/fwlink/?LinkID=179157).

另請參閱

顯示: